yield stress

英 [jiːld stres] 美 [jiːld stres]

屈服应力

化学



双语例句

  1. Assay analysis of Casson viscosity. Casson yield stress etc 23 indices of Hemorheology of 113 patients with cardio-cerebral diseases in Yanan
    延安市113例心脑血管病患者卡森粘度卡森屈服值等23项血流变指标测定与分析
  2. The transverse stress of clad material was analyzed with the mixing rule, and the results show that the yield stress, tensile stress and the thickness ratio obey exponent function.
    研究了陶瓷微粉含量对其介电性能的影响以及介电性能的频率和温度特性,并用介质混合法则对其介电常数进行拟合分析。
  3. Discussion on Prediction Accuracy of Yield Stress Model of Cold Rolling Mill
    冷连轧变形抗力模型预报精度的探讨
  4. A plastic constitutive model for concrete with zero value of initial yield stress under triaxial compressive loading condition
    零屈服应力下混凝土三轴受压塑性模型
  5. This instrument can be used for measuring the yield stress of ER fluids, MR fluids and EMR fluids.
    可以分别用于电流变液、磁流变液以及电磁流变液的测试。
  6. Temperature Field and Yield Stress Grads during Wire Die-Less Drawing of Tungsten Alloy
    钨合金丝材无模拉拔成形温度场及流动应力梯度
  7. As the role between the sands is so complex, the theoretical analysis of the Bingham yield stress has not been so perfect, and the analyzed calculation was much multitudinous.
    宾汉极限切应力是描述非牛顿体流变特性的一个重要参数,由于流体中泥沙颗粒之间作用的复杂性,使得宾汉极限切应力的理论分析还不完善,其解析计算也较繁琐。
  8. Vessel burst pressure is the mean between maximum event ( explosion) pressure and the yield stress of the vessel.
    容器爆破压力是容器屈服应力和最大事件(爆炸)压力之间的平均数。
  9. Artificial Neural Network Model to Predict Yield Stress of Waxy Crude Oil
    人工神经网络预测含蜡原油的屈服应力
  10. Calculation and Prediction of The Bingham Yield Stress Using BP Neural Network
    基于BP网络的宾汉极限切应力的计算和预测
  11. If an applied stress or pressure drop is not sufficient to break the gel or exceed the yield stress, no flow will occur.
    如果施加的应力或压降不足以破坏凝胶或不足以超过屈服应力,则不会有流动产生。
  12. It is relatively simple to predict the elastic modulus, yield stress and stress-strain response of the composites with different volume fraction of particles by the model.
    不但防水,还具有弹性。运用该模型可以很方便地预测不同颗粒体积含量复合材料的弹性模量、服应力、力-变塑性响应等。
  13. The magnitude of the yield stress of magnetorheological fluids is important for engineering applications.
    剪切屈服应力是磁流变流体固化强度的重要指标之一,具有重要的工程意义。
  14. Results showed that both sweet potato slurry with and without pectinase treatment behaved as non-Newtonian, pseudoplastic fluid with yield stress.
    结果表明:未经果胶酶处理和经过果胶酶处理的甘薯浆均为非牛顿性流体、呈现假塑性同时具有屈服应力。
  15. Studies have shown that ( in the same units) the hardness of a cold-worked metal is about three times its yield stress, Y;
    研究表明:(在相同的面积上)冷加工材料的硬度大约是它屈服强度的三倍;
  16. Thus cubic particle model can predict the minimum current density of a certain ER fluids needed to obtain a shear yield stress.
    这样可使用立方体颗粒模型来计算某一电流变液剪切屈服应力所对应的最小电流密度。
  17. The yield stress and shear-resistant properties of crosslinking polymer gel were studied by rheological measurement.
    采用控制应力流变仪研究了交联聚合物凝胶的屈服应力与凝胶强度的关系,并考察了凝胶的抗剪切性能,尤其是与油藏渗流速度相当的剪切速率下的凝胶的粘度保持率。
  18. The material flow, yield stress and flow stress were not apparently influenced by the deforming speed.
    变形速度对材料流动、屈服应力、流动应力没有明显影响。
  19. The effect of temperature on the yield stress is included in the numerical method.
    该格式同时也考虑了温度对屈服极限的影响。
  20. Especially, this model can also explain the yield stress and wall slip phenomena for foam fracturing fluid.
    更为主要的是该模型还可以用于解释泡沫压裂液的屈服应力和壁面滑移现象。
  21. Conventional yield stress, breaking stress and breaking extensibility of the blends with different proportions were also measured.
    测定了共混物的屈服应力、断裂应力和断裂伸长率。
  22. Also, the sensitivity of the temperature/ loading rate and the constitutive equation related to yield stress versus temperature/ strain rate both are made in the paper.
    计算了两种材料的温度敏感度和加载速率敏感度以及温度和应变率对两种树脂材料屈服应力影响的本构关系。
  23. The relationships of thickness ratio with yield stress and tensile stress of the clad were established.
    在传统的混合法则基础上,建立了宽度方向应力与相对厚度比和拉伸应变之间的关系。
  24. The effect of the definition of yield stress on hardening rules.
    不同屈服应力定义对强化规律的影响;
  25. The variations of the yield stress with strain are considered in the model.
    随变形而变化的屈服应力也在模型中被考虑。
  26. Elastic deformation occurs at stress below the yield stress, the viscous flow appears after yield with thixotropy.
    验证了在剪切应力低于屈服应力时,变形基本上是弹性的,而屈服后粘流过程显示了触变特性。
  27. Rotated rheometer was used to determine the yield stress of lithium lubricating grease.
    选用旋转流变仪测定了锂基润滑脂的屈服应力。